Instruction Manual
Table Of Contents
- Mr. Christmas Alexa Compatible LED Christmas Tree 7.5ft -Item # 68333 / 68337 9ft -Item # 68334 / 68338
- Slide Number 2
- Slide Number 3
- Slide Number 4
- Slide Number 5
- Slide Number 6
- Slide Number 7
- Slide Number 8
- Slide Number 9
- Slide Number 10
- Slide Number 11
- Slide Number 12
- Slide Number 13
- Slide Number 14
- Slide Number 15
- Slide Number 16
- Slide Number 17
1. I can’t connect my device to Alexa.
• Check that your Alexa device and the Alexa app have the latest software
version.
• Make sure that your Alexa device and the light strand are connected to the
same Wi-Fi network.
• Check that your device is within 30 ft. (9 m) of the light strand.
• Try setting your Christmas Tree LED light Mode to “STEADY” and then proceed
with the pairing process.
• Perform a factory reset : Press and hold the button on the control box of the
tree for 10-11 seconds. The tree lights will flash white 3 times. This indicates
that the instructions were received. Follow the instructions on page 8 to set
up your device with Alexa app.
2. I can’t get the light strand barcode to successfully scan.
• During the Alexa mobile app setup process, select “Don’t Have a Barcode”
• Follow the on-screen instructions.
3. My Light Strand stopped working with Alexa.
• Try a power cycle: Unplug your Christmas Tree from the outlet, and then plug
it back in.
• Perform a factory reset : Press and hold the button on the control box of the
tree for 10-11 seconds. The tree lights will flash white 3 times. This indicates
that the instructions were received. Follow the instructions on page 8 to set
up your device with Alexa app.
Connectivity Troubleshooting
Common connectivity troubleshooting steps.
16