User manual

15
C.
C. C.
C. OPERATION
OPERATIONOPERATION
OPERATION
C
CC
C-
--
-1 PRIOR TO STARTUP
1 PRIOR TO STARTUP1 PRIOR TO STARTUP
1 PRIOR TO STARTUP
1. Ensure the PIP-LC is in a suitable positioning.
2. Check and ensure all inputs cables are secured.
3. Make sure the load is disconnected or in the “OFF” position.
4. Check if input voltage meets the PIP-LC rating required.
5. Ensure batteries, loads (turned off), and AC cables are properly connected before switching on the
PIP-LC.
C
CC
C-
--
-2 OPERA
2 OPERA2 OPERA
2 OPERATIONS PROCEDURES
TIONS PROCEDURESTIONS PROCEDURES
TIONS PROCEDURES
Please follow the instructions below for PIP-LC operation.
1. Connect AC source (optional). *This inverter requires DC power to start, and AC is optional.
2. By pressing the Enter
By pressing the EnterBy pressing the Enter
By pressing the Enter-
--
-key and the Down
key and the Downkey and the Down
key and the Down-
--
-key simultaneously for
key simultaneously for key simultaneously for
key simultaneously for about
about about
about 3 seconds
3 seconds3 seconds
3 seconds, system greetings will
display and inverter will start up after two beeps and Normal LED lights up to indicate the power is from
its bypass AC main to the load.
3. When the Down
When the DownWhen the Down
When the Down-
--
-key and the Up
key and the Upkey and the Up
key and the Up-
--
-key are pressed simultaneously for 3 seconds
key are pressed simultaneously for 3 secondskey are pressed simultaneously for 3 seconds
key are pressed simultaneously for 3 seconds, the PIP-LC will be
turned off after two beeps. The system will remain in standby mode (Normal LED will keep blinking) until
AC input is completely disconnected.