User's Guide

MP280B User’s Guide
3
The requirement for KDB 996369 D03:
1 List of applicable FCC rules
FCC Part 15. 247.
2 Summarize the specific operational use conditions
None
3 Limited module procedures
The module is a single module, so this requirement is not applicable to the product.
4 Trace antenna designs
The module uses the permanent PCB antenna, so this requirement is not applicable to the
product.
5 RF exposure considerations
After evaluation, the SAR requirement is deemed to be satisfied without test. Please
check the report for detail information.
6 Antennas
PCB antenna, 3dBi.
7 Label and compliance information
If this certified module is installed inside the host device, then the outside of the host
must be labeled with “Contains FCC ID: 2AUXFMP280B”.
8 Information on test modes and additional testing requirements
The host manufacturer can use the software of SmartRF Studio 7 to make the Bluetooth
transmit continuously.
9 Additional testing, Part 15 Subpart B disclaimer
The module only complies with the FCC Part 15.247. If the module is installed in the
host device, the host manufacturer is responsible for the compliance to any other FCC
rules that apply to the host not covered by the modular transmitter grant of certification.
For example, if the host manufacturer markets their product as being Part 15 Subpart B
compliant (when it also contains unintentional-radiator digital circuity), then the host
manufacturer shall provide a notice stating that the final