XR-M7 CD MP3 MICROSYSTEM WITH USB READER USER MANUAL Please read and keep these instructions
Important safety instructions – please read carefully and keep for future reference To reduce the risk of fire or electric shock, do not expose this product to water, rain or moisture. To prevent the risk of electric shock, do not remove the cover or back of this product. In case of product failure, only qualified personnel can repair. There are no user-serviceable parts inside.
Electric supply - Please unplug the product in case of prolonged non-use. - If the supply cable is damaged, it must be replaced by the manufacturer or qualified after-sales personnel to avoid any danger. - This product must be connected to an electrical supply 230V ~ 50Hz. - The plug must be accessible after installation. This product is compliant with directives 2006/95/CE (abrogating the directive 73/23/CEE modified by the directive 93/68/CEE) and 2004/108/CE (abrogating the directive 89/336CEE).
INTRODUCTION Thank you for choosing this Schaub Lorenz product.
1、POWER ON/OFF 7、VOL ADJUST 2、CD/FM 8、USB 3、USB 9、REMOTE CONTROL SENSOR 4、PLAY/PAUSE(AUTO) 10、DISPLAY 5、OPEN/CLOSE 11、EARPHONE JACK 6、CD DOOR 12、Amplifier Output 13、FM antenna
1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21.
INSTALL THE REMOTE CONTROL BATTERY 1. Remove the battery door. 2. Install 2pc ``AAA`` battery into the battery bracket (batteries not provided). Make sure that the + symbol is respected 3. Close the battery door. Note: 1. Battery chemicals can cause a rash. If the batteries leak, clean the battery compartment with a cloth. If chemicals touch you skin, wash immediately. 2. If the remote control is not going to be used for an extended period of time, remove the batteries. 3.
MUTE In play status, If the MUTE button is pressed, there will be no audio output, the sound is eliminated. Then press this button again or press VOL+/- buttons to exit the mute status, the sound resumes to be its normal status. FAST REWIND / FAST FORWARD While playing the CD disc, press the button or button, the disc will play fast rewind or fast forward. Press the PLAY/PAUSE button to exit this status and resume to normal playing.
BASS/TREBLE In play status, press the BASS and TREBLE button on the remote control , and then press VOL-/+ to adjust the BASS and TREBLE value. This function provides a better quality of BASS and TREBLE sound. PLAYING USB Press the “CD/USB” button to switch to CD / USB playback. NOTE: If in FM mode ,please press CD/FM first to switch to CD mode before switch to USB Connecting a USB device 1) Insert a USB key inside the connector. 2) Press the CD / USB key to start.
select the 15th band. Press the CH- or CH+ button, the band will be switched up or down. 3) Automatically search bands: press the AUTO button, this unit will start to search bands from the lowest part to highest part automatically. Meanwhile the searched bands will be saved orderly. Press the button again to stop searching. 3. Soundtrack Selection Press the MO/ST button on the remote control, you may select Mono and Stereo soundtrack output in FM status.
No sound from Audio cable not connected or not Connect the cable as the connected securely diagram The volume is in the lowest status Turn the volume up loudspeaker Use a piece of clean and Disc not clean Discontinuous sound Operation cannot be done soft cloth to clean the disc Disc scratched Replace the disc with a Disc distorted new one Embedded micro computer fails due Power OFF, and restart to the lightning, static or interference other player after 10 seconds PLAYING USB P