Operation Manual

Page 11 Getting Started
English
Â 
Charging the Player
The player comes with a built-in rechargeable
lithium-polymer battery.
Charge the battery fully before using it for the rst
time. If the player has not been used in a while, the
battery may need to be recharged overnight (about
 hours).
To charge the battery:
1. Plug the small end of the included USB cable
into the player’s USB connector.
2. Plug the large end of the USB cable into a com-
puter’s USB 2.0 Hi-speed port. The LCD screen will
turn on and display the message USB connecting.
a. The computer must be turned on, and;
b. The USB port must be a high-power port.
High-power ports can usually be found on
the main computer unit.
3. Disconnect the player when it is fully charged.
The computer must be powered on and not
in sleep mode in order to charge the battery.
The player will not charge if it is connected to
a low-power USB port. Low-power ports may
be found on a peripheral device that is con-
nected to the computer (e.g., a keyboard).
If the player is connected to the computer
through a USB hub, the hub must be self-
powered to charge the battery.
TIP You can press and hold [ESCAPE] after the
player is connected to cancel the data con-
nection and switch to USB power mode. This
will allow you to use the player normally
while drawing power from the computer.