User manual

ADVANCED MENU
~22~
7.2 DETECTION
In this submenu, you can set up detection-related functions: DETECTION SETUP and DETECTION TIMER.
Move the cursor to “DETECTION”, and press ”ENTER”. The screen will show the following options.
ADVANCE DETECTION
CAMERA
TITLE DET AREA LS SS TS RE ALARM
DETECTION
CH1 ON SETUP 07 03 02 10 OFF
REMOTE
CH2 OFF SETUP 07 03 02 10 N.C.
DISPLAY
CH3 OFF SETUP 07 03 02 10 N.O.
ALERT
CH4 OFF SETUP 07 03 02 10 OFF
SYSTEM
NETWORK
PLEASE CONSULT YOUR INSTALLER FOR ADVANCE SETTING
BACKUP
uv SELECT s BACK t NEXT  ENTER
HDD INFO
EVENT LOG
The submenu items are described below:
1) TITLE: Show the camera title of each channel set in “CAMERA”.
2) DET: Select if you want to activate the motion detection function for the selected channel (ON/OFF).
3) AREA
Press “ENTER” button to set the detection area. You will see similar screens as the following:
Pink blocks represent the area that is not being detected while the transparent blocks are the area under
detection.
Note: If the connected video output device is LCD monitor, but the “MONITOR OUT” setting in “DISPLAY”
menu is "MAIN", the motion detection area setting will be disabled.
Transparent blocks are the area
under detection.
Press “ENTER” button to confirm the
start area.
Press “LEFT” / “RIGHT” button to
choose the width of the detection
area.
Press “UP” / “DOWN” button to
choose the height of the area.
You can also set up multi-detection
area.
When any movement is detected,
you will see the grids are flashing.