Setup guide

Preface

previously set password from CMOS memory. You may also

press [ESC] to abort the selection and not enter a password.

When the Supervisor Password is set, the new item User Access Level

and Password Check will be added in the menu. You can make further

settings of access right in the User Access Level item. Setting options:

No Access, View Only, Limited, and Full Access. The Password

Check item is used to specify the type of BIOS password protection that

is implemented. Settings are described below:

To clear a set password, just press [Enter] when you are prompted

to enter the password. A message box will show up confirming the

password will be disabled. Once the password is disabled, the

system will boot and you can enter Setup without entering any

password.

Supervisor Password allows the user to enter and change the

settings of the setup menu; User Password only allows the user to

enter the setup menu, but not to make changes.