User`s guide

MPC Computers 2005 © MAS001985-00

Preparing to Install a Wall-Mounting Arm

To prepare to install a wall-mounting arm, complete the following steps:

1 If the monitor is currently in use, turn it off and disconnect the power cord

and video cable.

2 Lower the display and re-insert the spring retention pin. (See white arrow

in Figure 6.)

3 Pull the screw cover off the back of the monitor if it is in place.

4 Carefully place monitor face down on a flat padded surface.

5 Support the base and remove the screws. (See black arrows in Figure 6.)

6 Remove the base and pedestal.

7 Follow the manufacturer's instructions to assemble the wall-mounting

arm.

Installing a Wall-Mounting Arm

To install the wall-mounting arm, complete the following steps:

1 Place the wall-mounting arm or mounting plate onto the back of the

monitor. Line up the holes of the arm or plate with the holes in the back of

the monitor.

2 Insert the four screws into the holes and tighten. (See black arrows in

Figure 6.) Be careful not to overtighten the screws.

3 Attach arm to mounting plate, if required.

4 Insert the power cable into the slot on the back of the monitor and

reconnect the video cable.

APPENDIX C — ON-SCREEN MESSAGES

Table 5: On-Screen Messages

Message Action

No Signal

• Check that the signal cable is properly

connected. If the connector is loose, tighten

the connector screws.

• Check the DB-15 plug on the video cable for

bent pins or other damage.

Input Not Supported

• Your system may be set outside the display

mode range of the monitor. Verify you are

using a compatible display mode. (See Table

6: Factory Preset Timing.)