User`s guide

•

This monitor has a universal power supply. It can operate in either a

100/120 VAC or 220/240 VAC voltage area (no user adjustment is

required).

• Make sure the power cord meets the specifications and

requirements for your area. The power cord included with your

monitor is rated for 100/120 VAC.

To connect the power cord to your monitor and a power source, follow

the steps below:

Caution: If the AC outlet is not grounded (with three holes), install the

proper grounding adapter (not supplied).

1 Plug the AC power cord into the supplied external power adapter

brick. Plug the small end of the power adapter cord (DC Plug) into

your monitor’s power input socket (DC Jack). See Figure 2.

Figure 2: Connecting Cables

2 Plug the other end of the power cord into a three-pin AC power outlet

or a UL-approved power strip.

Note: A certified power supply cord must be used with this equipment. The

relevant national installation and/or equipment regulations need to be

considered. A certified power supply cord not lighter than ordinary polyvinyl

chloride flexible cord according to IEC 60227 (designation H05VV-F 3G

0.75mm or H05VVH2-F2 3G 0.75mm) should be used. As an alternative, a

flexible cord of synthetic rubber, according to IEC 60245 (designation

H05RR-F 3G 0.75mm), can be used.