User Manual

6
Set path
running time
Click to confirm the path and set the running time. The next path can
be added after confirming the path. Click Confirm and the Slypod E will
run according to the setting after the countdown is over. At this point,
enter the Segmentation time-lapse interface, click on the red circular
area, the Slypod E can control the camera to take pictures. (Slypod E
needs to be connected to the camera with the camera control cable)
Click Start, the Slypod E
will run according to
the setting
● Step Time-Lapse
Select Step mode to set Travel Distance, Frame Number, Cycle
Setting, Exposure Time, Interval Time and FPS. Click “+”“-” to adjust the
parameter, click to start, the Slypod E will run according to the set
parameters, the interface will display Shooting Time Taken, Total
Shooting Time, Total number of photos. Enter the Step time-lapse
interface, click on the red circular area, the Slypod E can control the
camera to take pictures. (Slypod E needs to be connected to the
camera with the camera control cable)
Click on the red circular
area,
the Slypod E can control
the
camera to take pictures
Click on the red circular area,
the Slypod can control the
camera to take pictures