Users Manual

Step Time-lapse

Select step mode to set step length, cycle, residence time and step movement time.

After the setting is completed, tap “Start” and the device will move according to the set

step length, speed and cycle.

Firmware Upgrade

In the charging state, enter the APP interface after the device is connected to the APP,

and select the Firmware Upgrade to perform the upgrading. The device must be

restarted after the upgrade succeeds. If the upgrade fails, the process needs to be

repeated until the upgrade succeeds.

Charging

Uncover the rubber sleeve over the charging port, the Type-C interface is inside. The

Slypod can be charged by mobile phone charger, mobile power bank, etc. It will

automatically stop charging when the battery is full, please disconnect the charger then.

(It is recommended to use the original charging cable provided in the package)

Status Indicator

Solid red

Charging

Solid blue

Charging

completed

Power on Solid green

Under-voltage

alarm

Solid orange

Low voltage

alarm

Blinking red + automatic reset &shutdown

(blinking red, unable to power on while pressing the power button)

Blinking green

for 1s

Start/stop running switch

Blinking blue

for 1s

Testing/operating modes switch