Users Manual

Mounting the handle

Align the 1/4’’ screw hole on the handle with the 1/4’’ screw on the bottom of the

pole, turn the handle clockwise to tighten it.

Mounting the pan-tilt head

Slide the pan-tilt head into the groove at the top of the pole, make part 1 and

part 2 fully fit. Turn the screw ring 3 clockwise to secure the head onto the pole.

Loosen the screw ring 3, then turn the knob screw 4 anticlockwise to detach the

head from the pole. After the P&T head is detached,reset the quick release knob.

Mounting

(Mounting the adaptor) The same method as mounting the pan-tilt head.