Specifications

SONIC OWNERS MANUAL

10 Version 1.01

Move to the rear of the glider at the keel and pull back the double wire crossbar

restrainer cable so the stainless steel shackle will clip into the Bailey Block at the

rear of the keel.

9. The tip (#7) battens can now be installed. These battens locate onto the hook

found on the back side of the leading edge about 1 1/2 ft. inboard of the tip.

Sight through the sail at wingtip to ensure the end of the batten is engaged on

the hook, and secure with double bungee.

10. Insert the four under-surface battens. These are marked with dark blue bands.

Slide battens into appropriate pockets and secure with single loop bungies.

11. Move to nose of glider and insert nose batten, then fit nose fairing by matching

Velcro strips, and press to secure.

12. Be sure under-surface zipper is closed, and check that your hang loop and back-

up loops are in the correct position. Attach your harness to the hang loops,

ensuring that the carabineers are closed, the loops are the correct length, and

hanging straight from the keel.

FLAT SET UP

Move to the rear of the glider at the keel and pull back the double wire cross bar

restrainer cable. Raise the keel 10” (250mm) off the ground so the stainless

steel shackle will clip into the bailey block.

Check that hang loops are not damaged.