User's Manual

NPort W2150A/W2250A Series Web Console: Network Settings
7-4
Ethernet Bridge
Default Disabled
Options Enabled, Disabled
Description This field specifies whether to enable Ethernet Bridge mode or not. When Ethernet
Bridge is enabled, the LAN and WLAN interfaces are bridged together. Data can be
seamlessly transferred between serial lines, LAN, and WLAN. The LAN and WLAN will use
the LAN IP setting, and WLAN IP setting will be disabled.
Disabled: When disabled, you can use either the LAN or WLAN.
Enabled: When enabled, you can use both the LAN and the WLAN.
IP Configuration
Default Static
Options Static, DHCP, DHCP/BOOTP, BOOTP
Description This field determines how the NPort’s IP address will be assigned.
Static: IP address, netmask, and gateway are user-defined.
DHCP: IP address, netmask, gateway, DNS, and time server are assigned by the DHCP
server.
DHCP/BOOTP: IP address, netmask, gateway, DNS, and time server are assigned by the
DHCP server. IP address is assigned by BOOTP server if DHCP server does not respond.
BOOTP: IP address is assigned by the BOOTP server.
IP Address
Default 192.168.126.254
Options IP address (e.g., “192.168.1.1”)
Description This field is for the IP address that will be assigned to your NPort device server. An IP
address is a number assigned to a network device (such as a computer) as a permanent
address on the network. Computers use the IP address to identify and talk to each other
over the network. Choose a proper IP address that is unique and valid in your network
environment. If your device server will be assigned a dynamic IP address, set the IP
configuration parameter appropriately.