User's Manual

NPort W2150A/W2250A Series Web Console: Network Settings
7-3
Ethernet/Bridge Settings
To enable the Ethernet-to-Wireless function, also called Wireless Client, go to the Ethernet/Bridge
Settings page and enable Ethernet Bridge. When it's enabled, the LAN and WLAN will use the same IP
configuration (use the same IP address, netmask and gateway settings).
ATTENTION
In dynamic IP environments, the NPort will send three requests every 30 seconds to the DHCP or BOOTP
server until the network settings have successfully been assigned. The first request will time out after one
second; the second request will time out after three seconds, and the third request will timeout after five
second. If the DHCP or BOOTP server is unavailable, the NPort will use the factory default network settings.