User's Manual
Table Of Contents
- 10. Web Console: Restart
- 11. Installing and Configuring the Software
- A. SNMP Agents with MIB II & RS-232-Like Groups
- B. Well Known Port Numbers
- C. Ethernet Modem Commands
- D. Federal Communication Commission Interference Statement
- E. FCC Warning Statement
NPort W2150A/W2250A Series Federal Communication Commission Interference Statement
D-2
Information for the OEMs and Integrators
The following statement must be included with all versions of this document supplied to an
OEM or integrator, but should not be distributed to the end user.
1. This device is intended for OEM integrators only.
2. Please see the full Grant of Equipment document for other restrictions.
This radio transmitter FCCID: SLE-W2X50A has been approved by FCC to operate with the antenna types listed
below with the maximum permissible gain and required antenna impedance for each antenna type indicated.
Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type,
are strictly prohibited for use with this device.
Antenna List
No. Manufacturer Model No. Antenna Type Peak Gain
1 KINSUN ANT-WDB-ARM-02 Dipole Antenna 1.21 dBi for 2.4GHz
1.73 dBi for 5GHz
Note: The antenna connector is Reverse SMA type.