User`s manual

VPort 251 User’s Manual System Configuration
Step 2: Click on the Upgrade button to upload the firmware to the VPort.
Step 3: The system will start to run the firmware upgrade process.
Step 4: Once Firmware Update Success…..Reboot.... is shown, please wait for few seconds
for the VPort to reboot. The reboot process is finished once the STAT LED is lit
continuously in green.
NOTE
Upgrading the firmware upgrade will not change the original settings.
Reset to Factory Default
From the “Reset to Factory Default” page, click on OK (as shown in the following figure) to reset
the VPort to its factory default settings.
NOTE
All parameters will be reset to factory defaults when you use the Factory Default function. For
this reason, if you want to keep a digital copy of the current configuration, remember to export
the sys_config.ini file before using the Factory Default function.
Reboot
From the “Device Reboot” page, click on OK (as shown in the following figure) to restart the
VPort.
4-8