User`s manual

VPort 251 User’s Manual System Configuration
System Configuration by Web Console
System configuration can be done remotely with Internet Explorer. To access the server, type the
system configuration URL, http://<IP address of Video Server>/setup/config.html, to open the
configuration main page.
There are five configuration categories: System, Network, Video, Audio, and Alarm. A
description of each configuration item is shown in the table below:
Category Item Description and Contents
General Set Host Name and Date/Time
Accounts
Administrator, User, and Demo Account Privileges
Management
Diagnosis
Self-diagnostic report with system, communication,
power, and LED status
System Log System Log and operation information
System Parameter
System parameter information and Import/Export
functions
Firmware Upgrade Remote Firmware Upgrade
Factory Default Reset to Factory Default
System
Reboot Device will reboot for restarting system
General The IP network settings of this VPort
SMTP Server
Set up Primary and Secondary SMTP Server and e-mail
accounts
FTP Server Set up the Primary and Secondary FTP Server
DDNS Configure Dynamic DNS service
Universal PnP Enable UPnP function
Multicast Setting Set up Multicast (IGMP) Streaming
Accessible IP
Set up a list to control the access permission of clients
by checking their IP address
SNMP
Configure the SNMP settings
QoS (ToS)
Configure ToS(Type of Service)
Network
HTTP Event Server
Set up the HTTP Event Server to send the event alarm
action
Image Setting Configure the attributes of the video image
Camera Modulation Select the camera’s modulation (NTSC, PAL or AUTO)
Video Performance Set up the Size (Resolution), FPS, and Video Quality
Video
Camera Control Set up the Camera’s PTZ Control
Audio
Quality Set up the audio source
System Alarm Configure Network Connection Broken alarms
Basic General settings of event alarm
Schedule Set up the Alarm schedule
Video
Motion
Detection
Configure the Video Motion Detection Alarm
Digital Input Configure the Digital Input Alarm
Video Loss Configure the Video Loss Alarm
Alarm
Event
Alarm
Sequential
Snapshot
Set up the Sequential Snapshot operation
This table can also be found on the System Configuration Æ Overview webpage.
4-2