User`s manual

VPort 251 User’s Manual Getting Started
NOTE
The PTZ control panel or keyboard must support the control of PTZ camera being used.
Step 5: Configure the VPort 251’s IP address
When the VPort 251 is first powered on, the POST (Power On Self Test) will run for a few
moments. The STAT LED will turn green when the POST is complete. The NETWORK LED will
then flash as the IP address is assigned. The network environment determines how the IP address
is assigned.
Network Environment with DHCP Server:
For this network environment, the unit’s IP address will be assigned by the network’s DHCP
server. Refer to the DHCP server’s IP address table to determine the unit’s assigned IP address.
You may also use the Moxa VPort and Ether Device Configurator Utility (edscfgui.exe) as
follows:
2-3