User`s manual

VPort 25 User’s Manual First Time Installaton and Configuration
2-14
Step 10: Complete the hardware installation.
Software Installation
Step 1: Configure the VPort 25’s IP address
When the VPort 25 is first powered on, the POST (Power On Self Test) will run for a few
moments. The System LED will turn green when the POST is complete. The 10 Mbps or 100
Mbps LED will then flash as the IP address is assigned. The network environment determines how
the IP address is assigned.
Network Environment with DHCP Server
For this network environment, the unit’s IP address will be assigned by the network’s DHCP
server. Refer to the DHCP server’s IP address table to determine the unit’s assigned IP address.
You may also use the Moxa VPort and Ether Device Configurator Utility (edscfgui.exe), as
described below:
Using the Moxa VPort and EtherDevice Configurator Utility (edscfgui.exe)
1. Run the edscfgui.exe program to search for the VPort. After the utility’s window opens, you
may also click on the Search button
to initiate a search.