User`s manual

VPort 25 User’s Manual Introduction
1-11
Text LED Description
D7 Power On: power on
Off: power off
D8 100 Mbps On: Ethernet link is 100 Mbps
D9 10 Mbps On: Ethernet link is 10 Mbps
Red On Hardware initialization
Red blinking Software initialization
Green On System boot-up
D12 System
Green blinking Firmware upgrade proceeding
DIP Switch 1 Reserved
DIP Switch 2 Enable/
Disable
LED light
On: LED light is on
Off: LED light is off
Reset Button
This reset button can activate the hardware reset process.
1. Reboot:
To reboot the VPort 25, power it off and then power it back on again, or push the RESET button
one time. The System LED will light in red as the POST (Power on Self Test) process runs. When
the rebooting process is finished, the System LED will change to a green color.
2. Restore to Factory Settings:
To restore the VPort 25 to the factory default settings, press the reset button continuously until the
System LED blinks in red. After the system LED stops blinking, release the reset button. The
POST process will run, and the VPort will reboot. The System LED will light in green when the
VPort has finished rebooting.
Analog Video Output
The analog video output with standard BNC connector (1 Vpp, 75ohm) is for users who want to
check if the camera lens is tuned properly, or if the analog video signal is normal when there is a
problem with the IP video stream.
RJ45 Ethernet Port
The RJ45 Ethernet port is for network transmission. In addition, the VPort 25 camera supports
PoE (Power over Ethernet). What this means is that if you connect the VPort 25’s RJ45 port to a
PSE (Power Source Equipment) device, the VPort 25 can get all of its power through its Ethernet
port.
Inner Case Fastener
There are 4 fasteners located next to the Pan Rotation Plate for fixing the inner case.