User`s manual

Moxa VPort 16-M12 Getting Started
2-3
Step 4: To tune lens position, loosen the screws that fix the camera’s horizontal and vertical axes;
next, users may position the camera according to previously marked calibrations, or via the VPort
16-M12’s web console. After the desired lens position has been acquired, affix the screw
Step 5: Affix the top cover, and the installation is completed.
For Panel Mounts
Re-fasten the 4 base cover screws directly into
the base.
For Flush Mounts
Fasten the top (base) cover with the 4 screws
(accessories) as shown
NOTE
For flush mounts, the 4 top (base) cover screws will fix the VPort 16
-
M12’s top cover to a ceiling panel of 5 mm
thickness, maximum. If the standard M4 screws are inadequate, customers may contact their Moxa sales rep
to order longer screws.
Software Installation
Step 1: Configure the VPort 16-M12’s IP address
When the VPort 16-M12 is first powered on, the POST (Power On Self Test) will run for a few moments (about
30 seconds). The network environment will determine how the IP address is assigned.
Network Environment with DHCP Server
When automatically assigning IP addresses via DHCP server, refer to the DHCP server’s IP address table to
determine the unit’s assigned address. You may also use the Moxa VPort and Ether Device Configuration Utility
(edscfgui.exe), as described below:
Using the Moxa VPort and EtherDevice Configuration Utility (edscfgui.exe)
1. Run the edscfgui.exe program to search for the VPort device. After the application window opens, click on
the Search button to initiate a search.
2. When the search has concluded, the VPort’s Model Name, MAC address, IP address, serial port, and HTTP
port should be listed in the utility’s window.