User`s manual

Moxa VPort 16-M12 Introduction
1-8
Bottom View
• PoE & Etherent M12 connector: A 4-pin M12 A-code connecter for both PoE power supply (Mode A) and
Auto MDI/MDI-X Ethernet connections.
NOTE
To connect the VPort 16
-M12 to a network, use Ethernet cables with D-
code M12 connectors and either an M12
PoE or RJ45 P
oE switch
M12 D-code to M12 D-code
cable
M12 PoE Switch
(ex. TN-5508-4PoE)
M12 D-code and RJ45 cable RJ45 PoE switch
(ex. EDS-P510)
NOTE
The power input rating for the VPort 16
-M12 is 48V/0.17A, with a maximum power consumption of
about 6.5W.
NOTE
This equipment is designed for interior installations only, and is not intended for use in exposed (exterior)
networks.
• Reset button: Loosen the screw and use a pointed wire to depress the reset button for either simple
rebooting or resetting to factory defaults.
 Reboot: Depress the button one time, and release.
 Reset to factory defaults: Depress the button and hold for at least 15 seconds.