User's Manual

UC-2100-W Series Hardware

Hardware Connection Description

3-7

Adjusting the DIP Switch

The UC-2114 and UC-2116 models come with one DIP switch for users to adjust the serial port parameters. To

set up the DIP switch, do the following:

1. Remove the screws on the DIP switch cover located on the rear panel of the

device.

2. Remove the thin film on the DIP switch and adjust the settings as required.

Refer to the table below for the DIP switch settings. The default value is

OFF.

1 2 3 4

Low High Term. –

ON 1KΩ 1KΩ 120Ω –

OFF 150KΩ 150KΩ – –