User Manual

- 7 -
Console Port
The console port is an RS-232 port that can be connected to with a 4-pin
pin header cable. You can use this port for debugging or firmware
upgrade.
Pin
Signal
1
TxD
2
RxD
3
NC
4
GND
USB Port
The USB 2.0 port is located at the lower part of the front panel and
supports a USB storage device driver. By default, the USB storage is
mounted at
/mnt/usbstorage.
Antenna Connectors
There are three antenna connectors on
the front panel of the UC-8100A-ME-T.
W1 and W3 are for cellular modules, and
W2 is for the GPS module. All three
connectors are of SMA type.
Real-time Clock
The real-time clock in the UC-8100A-ME-T is powered by a lithium battery.
We strongly recommend that you do not replace the lithium battery
without the help of a Moxa support engineer. If you need to change the
battery, contact the Moxa RMA service team.
ATTENTION
There is
a risk of explosion if the battery is replaced with an
incorrect type of battery.
Accessing the UC-8100A-ME-T Using a PC
You can use a PC to access the UC-8100A-ME-T by one of the following
methods: