User Manual

- 12 -
Installing Micro SIM Cards
You will need to install a Micro SIM card on your UC-5100 computer.
Follow these steps to install the Micro SIM card.
1. Remove the screw on the cover
located on the front panel of the
UC-5100.
2. Insert the Micro SIM card into the
socket. Make sure you place the
card in the right direction.
To remove the Micro SIM card,
simply push the Micro SIM card and
release it.
Note: There are two Micro SIM card
sockets allowing users to install two
Micro SIM cards simultaneously.
However, only one Micro SIM card
can be enabled for use.
Installing the SD Card
The UC-5100 Series computers come with a socket for storage
expansion that allows users to install an SD card.
Follow these steps to install the SD card:
1. Unfasten the screw and remove
the panel cover.
The SD socket is located on the
front panel of the computer.
2. Insert the SD card into the
socket. Ensure that the card is
inserted in the right direction.
3. Replace the cover and fasten the
screw on the cover to secure the
cover.
To remove the SD card, simply push
the card in and release it.
Adjusting the CAN DIP Switch
The UC-5111 and UC-5112 computers come with one CAN DIP switch
for users to adjust the CAN termination resistor parameters. To set up
the DIP switch, do the following:
1. Find the DIP switch location on the
top panel of the computer
2. Adjust the setting as required. The
ON value is 120Ω, and the default
value is OFF.