UC-3100 Quick Installation Guide Edition 2.0, July 2018 Technical Support Contact Information www.moxa.com/support Moxa Americas: Toll-free: 1-888-669-2872 Tel: 1-714-528-6777 Fax: 1-714-528-6778 Moxa China (Shanghai office): Toll-free: 800-820-5036 Tel: +86-21-5258-9955 Fax: +86-21-5258-5505 Moxa Europe: Tel: +49-89-3 70 03 99-0 Fax: +49-89-3 70 03 99-99 Moxa Asia-Pacific: Tel: +886-2-8919-1230 Fax: +886-2-8919-1231 Moxa India: Tel: +91-80-4172-9088 Fax: +91-80-4132-1045 2018 Moxa Inc.
Overview Moxa’s UC-3100 Series computers can be used as smart edge gateways for data pre-processing and transmission, as well as for other embedded data-acquisition applications. The UC-3100 Series includes three models, UC-3101, UC-3111 and UC-3121, each supporting different wireless options and protocols. Please refer to the datasheet for more information.
UC-3111 UC-3121 -3-
LED Indicators LED Name SYS Status Function Notes Green Red Off Power is on FN button is pressed Power is off Refer to the Function Button (FN Button) and LED Indicators section in the hardware/software user manual for more details.
Wall Mounting (Optional) The UC-3100 can also be wall mounted. The wall-mounting kit needs to be purchased separately. Refer to datasheet for more information. 1. Fasten the wall-mounting kit to the UC-3100 as shown below: 2. Use two screws to mount the UC-3100 on to a wall. Connector Description Power Connector Connect the power jack (in the package) to the UC-3100’s DC terminal block (located on the bottom panel), and then connect the power adapter. It takes several seconds for the system to boot up.
Ethernet Port The 10/100 Mbps Ethernet port uses the RJ45 connector. The pin assignment of the port is shown below: Pin 1 2 3 4 5 6 7 8 Signal Tx+ TxRx+ – – Rx– – Serial Port The serial port uses the DB9 male connector. It can be configured by software for the RS-232, RS-422, or RS-485 mode.
SIM Card Socket The UC-3100 comes with two nano-SIM card sockets for cellular communication. The nano-SIM card sockets are located on the same side as the antenna panel. To install the cards, remove the screw and the protection cover to access the sockets, and then insert the nano-SIM cards into the sockets directly. You will hear a click when the cards are in place. The left socket is for SIM 1 and the right socket is for SIM 2. To remove the cards, push the cards in before releasing them.
Real-Time Clock The real-time clock in the UC-3100 is powered by a lithium battery. We strongly recommend that you do not replace the lithium battery without the help of a Moxa support engineer. If you need to change the battery, contact the Moxa RMA service team. ATTENTION There is a risk of explosion if the battery is replaced with an incorrect type of battery. Accessing the UC-3100 Using a PC You can use a PC to access the UC-3100 by one of the following methods: A.
