User Manual

UC-2100 Series Hardware Introduction
2-7
Placement Options
There are two sliders on the back of the unit for DIN-rail and wall mounting.
Wall or Cabinet Mounting
Mounting UC-2100 on the wall requires 2 screws. The heads of the screws should be less than 7.0 mm in
diameter, the shafts should be less than 3 mm in diameter, and the length of the screws should be more than
8 mm, as shown in the figure at the bottom.
NOTE
Before tightening the screws into the wall, make sure the screw head and shank size are suitable by inserting
the screw into
one of the keyhole-shaped apertures of the wall mounting plates.
DIN-Rail Mounting (Optional)
The UC-2100 comes with an optional DIN-rail mounting kit for users to install the computer onto a DIN rail.
Install the DIN-rail mounting kit on the computers two mounting ears, then install the computer onto a
DIN-rail rack.