User`s manual

TN-5516/5518 Series Featured Functions
3-66
STEP 1—Set up the connected devices
Set up those Ethernet-enabled devices connected to TN-5500
for which you would like IP addresses to be assigned
automatically. The devices must be configured to obtain their IP
address automatically.
The devices’ configuration utility should include a setup page
that allows you to choose an option similar to Obtain an IP
address automatically.
For example, Windows’ TCP/IP Properties window is shown at
the right. Although your device’s configuration utility may look
quite a bit different, this figure should give you some idea of
what to look for.
You also need to decide which of TN-5500’s ports your
Ethernet-enabled devices will be connected to. You will need to
set up each of these ports separately, as described in the
following step.
STEP 2
Configure TN-5500’s Set device IP function, either from the Console utility or from the Web Browser interface.
In either case, you simply need to enter the Desired IP for each port that needs to be configured.
STEP 3
Be sure to activate your settings before exiting.
When using the Web Browser interface, activate by clicking on the Activate button.
When using the Console utility, activate by first highlighting the Activate menu option, and then press
Enter. You should receive the Set device IP settings are now active! (Press any key to continue)
message.
Configuring Set Device IP
Desired IP Address
Setting Description Factory Default
IP Address Set the desired IP of connected devices. None