User`s manual

RNAS-1200 Series Managing Drives and Storage
7-4
Scanning Disks and Arrays
Activating the Scan utility will unmount the drives and initiate a file tree scan of the entire file system by calling
the
fsck command. Fsck will be run using the prune (i.e., auto-repair) and force flags; these will
automatically repair the file system (-p) and force (-f) a file system check even if the file tree appears clean.
Please note that scanning the disk may cause some unrecoverable data loss. Click OK if you wish to
scan the disk, or Cancel to quit.
ATTENTION
It is not always advisable to use the fsck utility, and when used improperly the command may irreversibly
damage your system. Read up on proper fsck usage before putting it to use.
Viewing Disk Volumes
Click Disk Volumes from the DISK tab to view the disk volume stats.
Creating a Disk Volume
This is the section of the RNAS setup interface where you may configure a RAID architecture. To access the
page, select RAID from within the DISK tab.
The following four RAID architectures are available: