User`s manual

RNAS-1200 Series Hardware Connection Description

3-5

RNAS-1200 Administration

Power up the RNAS-1200 computer and verify that the power source is ready. Once the operating system boots

up, the first step is to use the administrator account to configure the Ethernet interface. The factory default IP

settings are show below:

Default IP Address Netmask

LAN1 192.168.3.127 255.255.255.0

LAN2 192.168.4.127 255.255.255.0

You may use a web browser to access the RNAS-1200’s configuration wizard. Simply connect to the RNAS-1200

over either LAN port, enter the appropriate IP address into a browser, and when prompted use admin as the

default username and password.

Password: admin

To go directly to the RNAS-1200’s IP configuration, click the Network tab in the main toolbar. There, you may

set the Ethernet interfaces for static or DHCP addressing. To set up a static IP address, disable DHCP and then

enter the IP address, subnet mask and gateway information in the specified fields. If two different gateways are

configured, it will be necessary to select which LAN port will serve as the default gateway. Finally, enter DNS

information in the bottom section of the page. When finished, click Apply to complete.

The networking configuration interface is shown on the following page of this installation guide, with the main

IP addressing parameters highlighted.