User`s manual

RNAS-1200 Series Hardware Connection Description
3-3
No. 10/100 Mbps 1000 MBps
1 – TRD3+
2 – TRD4+
3 – TRD4-
4 ERx- TRD1-
5 ETx+ TRD2+
6 ERx+ TRD1+
7 – TRD3-
8 ETx- TRD2-
Installing the Storage Drive
The RNAS-1200 Series has two SATA connectors for two SATA disks. The RNAS-1211 model comes with two
pre-installed 100 GB hard disk drives. . To install SATA storage drives into the RNAS-1201, refer to the
following figures.
Step 1: Remove the two screws on the front panel.
Step 2: Remove the four screws on the rear panel.
Step 3: Remove the top cover of the RNAS-1200.
Step 4: Remove the four screws on the drive’s mounting tray, and remove the tray from the RNAS.
Step 5: Situate the drive so that its four holes match up with the tray’s mounting holes.
Step 6: Affix the drive to the mounting tray using the four screws you have just removed.
Step 7: Re-affix the mounting tray (with the now mounted storage drive on top) to the RNAS drive slot.
Step 8: To install the second drive, repeat steps four through seven. .
Step 9: Secure the enclosure by reversing the first 3 steps of this procedure.