User`s manual

RNAS-1200 Series Hardware Connection Description
3-2
Installing the RNAS-1200
Wall or Cabinet Mounting
The RNAS-1200 provides two mounting kits, for either walls or cabinets.
Attach the brackets to either side of the chassis with the included screws
Connecting the Power
To power on the RNAS-1200, simply connect the Ethernet port to any Ethernet switch that supports PoE or
PoE+. Once the system is fully powered and initialized, the Ready LED will light up.
ATTENTION
If
the RNAS-1200 has connected to a PoE switch, and T1 mode has been configured, it can only boot
up when
the ambient temperature is above 0
°C.
Connecting to the Network
Plug your network cable into the RNAS-1200’s Ethernet port. The other end of the cable should be plugged into
your Ethernet network. When the cable is properly connected, the LEDs on the RNAS-1200’s Ethernet port will
glow to indicate a valid connection.
The 10/100/1000 Mbps Ethernet LAN port uses 8-pin M12 connectors. The following diagram shows the pinouts
for these ports.