User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Featured Functions
- Configuring Basic Settings
- Using Port Trunking
- Configuring SNMP
- Using Communication Redundancy
- Using Traffic Prioritization
- Using Virtual LAN
- Using Multicast Filtering
- Using Bandwidth Management
- Using Port Access Control
- Using IP Filter
- Using Auto Warning
- Using Line-Swap-Fast-Recovery
- Using Set Device IP
- Using Diagnosis
- LLDP
- Using Monitor
- Using the MAC Address Table
- Using System Log
- Using HTTPS/SSL
- A. MIB Groups
- B. Specifications
- C. Modbus/TCP Map
PT-7728 User’s Manual Featured Functions
3-78
A
A
Appendix A MIB Groups
The PT-7728 comes with built-in SNMP (Simple Network Management Protocol) agent software
that supports cold/warm start trap, line up/down trap, and RFC 1213 MIB-II.
The standard MIB groups that the PT-7728 supports are as follows:
MIB II.1 – System Group
sysORTable
MIB II.2 – Interfaces Group
ifTable
MIB II.4 – IP Group
ipAddrTable
ipNetToMediaTable
IpGroup
IpBasicStatsGroup
IpStatsGroup
MIB II.5 – ICMP Group
IcmpGroup
IcmpInputStatus
IcmpOutputStats
MIB II.6 – TCP Group
tcpConnTable
TcpGroup
TcpStats
MIB II.7 – UDP Group
udpTable
UdpStats