User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Initial IP Address Configuration
- 4. Introducing Serial Port Operation Modes
- 5. Introducing OnCell Central and Ethernet Operation Modes
- 6. Using the Web Console
- 7. Cellular Network Settings
- 8. Configuring Serial Port Operation Modes
- 9. Configuring the Cellular-Enabling Ethernet Device
- 10. Configuring OnCell Central Management Software
- 11. Additional Serial Port Settings
- 12. System Management Settings
- 13. Software Installation/Configuration
- A. Pinouts and Cable Wiring
- B. RFC2217
- C. Dynamic Domain Name Server
- D. Well Known Port Numbers
- E. Auto IP Report Protocol
- F. GSM Alphabet
- G. Default Settings

OnCell G3111/G3151/G3211/G3251 Series User’s Manual Configuring OnCell Central Software
10-2
Step 1: Server Settings
System Requirements
Hardware Requirements
Please ensure that your host hardware meets the following minimum requirements:
Pentium III or above
500 MHz CPU (1 GHz recommended)
256 Mb RAM (1 GB recommended)
300 MB disk space
Software Requirements
OnCell Central Manager runs on a the following host systems:
– Microsoft Windows 2000 Server
– Microsoft Windows Server 2003
– Microsoft Windows Server 2008
– Internet Explorer 6.0 above is required.
Installation
Installing OnCell Central Manager software involves two main elements:
If needed, installing Adobe Flash.
Installing the OnCell Central Manager software.