User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Initial IP Address Configuration
- 4. Introducing Serial Port Operation Modes
- 5. Introducing OnCell Central and Ethernet Operation Modes
- 6. Using the Web Console
- 7. Cellular Network Settings
- 8. Configuring Serial Port Operation Modes
- 9. Configuring the Cellular-Enabling Ethernet Device
- 10. Configuring OnCell Central Management Software
- 11. Additional Serial Port Settings
- 12. System Management Settings
- 13. Software Installation/Configuration
- A. Pinouts and Cable Wiring
- B. RFC2217
- C. Dynamic Domain Name Server
- D. Well Known Port Numbers
- E. Auto IP Report Protocol
- F. GSM Alphabet
- G. Default Settings

OnCell G3111/G3151/G3211/G3251 Series User’s Manual System Management Settings
12-10
Encode format:
SMS Data Format
Text ASCII (7 bits) (default)
7 bits text format (160 bytes per packet)
Binary
8 bits binary (140 bytes per packet)
Unicode
16 bits Unicode (UCS2) format (70 bytes per packet)
Maintenance
Console Setting
On this screen, access to different OnCell G3111/G3151/G3211/G3251 configuration console
options (HTTP, HTTPS, Telnet, SSH) can be enabled or disabled. Please refer to Change Password
later in this chapter for more information on passwords. Finally, you may also enable or disable the
reset button.
Enable(default) :
always workable
Disable after 60 sec:
Reset button will not workable after 60 sec. This is protect reset button for
incidental press