User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Initial IP Address Configuration
- 4. Introducing Serial Port Operation Modes
- 5. Introducing OnCell Central and Ethernet Operation Modes
- 6. Using the Web Console
- 7. Cellular Network Settings
- 8. Configuring Serial Port Operation Modes
- 9. Configuring the Cellular-Enabling Ethernet Device
- 10. Configuring OnCell Central Management Software
- 11. Additional Serial Port Settings
- 12. System Management Settings
- 13. Software Installation/Configuration
- A. Pinouts and Cable Wiring
- B. RFC2217
- C. Dynamic Domain Name Server
- D. Well Known Port Numbers
- E. Auto IP Report Protocol
- F. GSM Alphabet
- G. Default Settings

OnCell G3111/G3151/G3211/G3251 Series User’s Manual Configuring OnCell Central Software
10-22
Server
This section describes ways in which you can change the connection ports number for device and
host in order to establish the connection with OnCell Central Server. If you would like to change
your account settings, you are able to change in this section.
Overview
The page shows the OnCell Central Manager version number that you are using.
Control Ports/User Ports info.
Control Ports info.
The purpose for control ports are used to establish the connection of OnCell device to OnCell
Central Server. This section shows all the controls ports information that have been set.
User Ports info.
The purpose for user ports are used to establish the connection of host to OnCell Central Server.
This section shows all the user ports range that you have been set. Please refer this chapter 8 for
each user ports explanation.