User Manual

- 4 -
Check the relay output first. If the
Ready LED is still blinking after
resolving the relay output, then
there is an IP conflict, or the DHCP
or BOOTP server did not respond
properly.
Flashing
quickly
microSD card failed
Green
Steady on
Power is on, and the NPort is
functioning normally.
Blinking The device server has been
located by Administrator’s
Location function
Off
Power is off, or a power error condition exists.
WLAN (Only for
the NPort
IAW5000A-I/O)
Green
Steady on
Wireless is enabled
Blinking
NPort can’t establish WLAN
connection with AP
(Infrastructure) or station
(Ad-Hoc)
Off
Wireless is not enabled.
Signal Strength
(3 LEDs only for
the NPort
IAW5000A-I/O)
Green
1 Bottom
The signal strength (RSSI) is less
than -74 dBm
2 Middle
The signal strength (RSSI) is
between -65 to -74 dBm
3 Top
The signal strength (RSSI) is
greater than -65 dBm
Ethernet
Amber
10 Mbps Ethernet connection
Green
100 Mbps Ethernet connection
Off
The Ethernet cable is disconnected or has a
short.
P1, P2 (Serial)
Amber
Serial port is receiving data.
Green
Serial port is transmitting data
Off
No data is being transmitted or received
through the serial port.
DI
Green
DI status on
Off
DI status off
DO
Green
DO status on
Off
DO status off
Hardware Installation Procedure
STEP 1:
After unpacking the unit, connect the power supply to the unit.
STEP 2:
Use an Ethernet cable to connect the unit to the network.
STEP 3:
Connect your device to the desired port on the unit.
STEP 4:
Place or mount the unit. The unit may be placed on a
horizontal surface such as a desktop, or mounted on the wall.
Mounting Options
The NPort IA5000A-I/O and IAW5000A-I/O are designed to be attached
to a DIN rail or mounted on a wall.