Datasheet

ManualsBrandsMoxa Manualscomputer componentsNPORT 5650-8-DTL

www.moxa.com

NPort 5600-DTL Series

8-port RS-232/422/485 serial device servers

Features and Benefits

• 8 serial ports supporting RS-232/422/485

• Compact desktop design

• 10/100M auto-sensing Ethernet

• Configure by Telnet, web browser, or Windows utility

• Supports Real COM and TCP server, TCP client, UDP socket modes

• SNMP MIB-II for network management

Certifications

Introduction

NPort® 5600-8-DTL device servers can conveniently and transparently connect 8 serial devices to an Ethernet network, allowing you to network

your existing serial devices with basic configurations. You can both centralize management of your serial devices and distribute management

hosts over the network. The NPort® 5600-8-DTL device servers have a smaller form factor than our 19-inch models, making them a great choice for

applications that need additional serial ports when mounting rails are not available.

Convenient Design for RS-485 Applications

The NPort® 5650-8-DTL device servers support selectable 1 kilo-ohm and 150 kilo-ohms pull high/low resistors and a 120-ohm terminator. In some

critical environments, termination resistors may be needed to prevent the reflection of serial signals. When using termination resistors, it is also

important to set the pull high/low resistors correctly so that the electrical signal is not corrupted. Since no set of resistor values is universally

compatible with all environments, NPort® 5600-8-DTL device servers use DIP switches to allow users to adjust termination and pull high/low

resistor values manually for each serial port.

LED Indicators to Ease Your Maintenance Tasks

The System LED, Serial Tx/Rx LEDs, and Ethernet LEDs (located on the RJ45 connector) provide a great tool for basic maintenance tasks and help

engineers analyze problems in the field. The NPort® 5600’s LEDs not only indicate current system and network status, but they also help field

engineers monitor the status of attached serial devices.

Appearance

Summary of content (5 pages)

PAGE 1
NPort 5600-DTL Series 8-port RS-232/422/485 serial device servers Features and Benefits • 8 serial ports supporting RS-232/422/485 • Compact desktop design • 10/100M auto-sensing Ethernet • Configure by Telnet, web browser, or Windows utility • Supports Real COM and TCP server, TCP client, UDP socket modes • SNMP MIB-II for network management Certifications Introduction NPort® 5600-8-DTL device servers can conveniently and transparently connect 8 serial devices to an Ethernet network, allowing you to net
PAGE 2
Specifications Ethernet Interface 10/100BaseT(X) Ports (RJ45 connector) 1 Magnetic Isolation Protection 1.5 kV (built-in) Ethernet Software Features Configuration Options Serial Console, Telnet Console, Web Console (HTTP/HTTPS), Windows Utility Management ARP, BOOTP, DHCP Client, DNS, HTTP, HTTPS, ICMP, IPv4, LLDP, Rtelnet, SMTP, SNMPv1/v2c, Telnet, TCP/IP, UDP Filter IGMP v1/v2 Windows Real COM Drivers Windows 95/98/ME/NT/2000, Windows XP/2003/Vista/2008/7/8/8.
PAGE 3
Power Parameters Input Current NPort 5610-8-DTL Series: 340 mA @ 12 VDC NPort 5650-8-DTL Series: 470 mA @ 12 VDC NPort 5650I-8-DTL Series: 740 mA @ 12 VDC No. of Power Inputs 1 Input Voltage 12 to 48 VDC Reverse Polarity Protection Supported Source of Input Power Power input jack Physical Characteristics Housing Metal Dimensions (with ears) 229 x 135.43 x 46 mm (9.02 x 5.33 x 1.81 in) Dimensions (without ears) 197 x 135.43 x 44 mm (7.76 x 5.33 x 1.
PAGE 4
Package Contents Device 1 x NPort 5600-DTL Series device server Installation Kit 1 x wall-mounting kit Cable 1 x Ethernet, RJ45 Power Supply 1 x power adapter, suitable for your region (except -T models) Documentation 1 x quick installation guide 1 x warranty card Dimensions Ordering Information Serial Interface Serial Interface Connector Serial Interface Isolation Operating Temp.
PAGE 5
PWR-12200-DT-S1 Desktop power supply (requires power cord), 12 VDC, 2 A, 100-240 VAC, 0 to 40°C operating temperature Power Cords PWC-C13AU-3B-183 Power cord with Australian (AU) plug, 1.83 m PWC-C13CN-3B-183 Power cord with three-prong China (CN) plug, 1.83 m PWC-C13EU-3B-183 Power cord with Continental Europe (EU) plug, 1.83 m PWC-C13JP-3B-183 Power cord with Japan (JP) plug, 7A/125V, 1.83 m PWC-C13UK-3B-183 Power cord with United Kingdom (UK) plug, 1.