NPort 5400 Series Quick Installation Guide Edition 7.1, November 2018 Technical Support Contact Information www.moxa.
Overview Welcome to Moxa’s NPort 5400 Series, a 4 port communication device that allows you to control RS-232 (for NPort 5410), RS-422/485 (for NPort 5430/5430I) or RS-232/422/485 (for NPort 5450/5450I) serial devices over a TCP/IP based Ethernet. Besides, NPort 5450-T and NPort 5450I-T are designed to use in wide temperature environment. NPort 5400 Series is a Moxa Green Product.
NPort 5410/5450/5450I NPort 5430/5430I -3-
NPort 5450-T/5450I-T Reset Button—Press the Reset button continuously for 5 sec to load factory defaults: Use a pointed object, such as a straightened paper clip or toothpick, to press the reset button. This will cause the Ready LED to blink on and off. The factory defaults will be loaded once the Ready LED stops blinking (after about 5 seconds). At this point, you should release the reset button. LED Indicators—NPort 5400’s top panel contains six LED indicators, as described in the following table.
LCM Display Panel (not support in -T model)—When the NPort 5400 unit is powered up, you will a see a display similar to: N 1 P 9 5 2 4 . 1 1 0 6 _ 8 6 . 1 1 4 2 0 7 5 . 2 5 4 This is where NP5410_61405 is the server’s name, and 192.168.127.254 is the server’s IP address. LCM Panel Operation (not support in -T model)—There are four buttons on NPort 5400’s top panel used to operate the server’s LCM panel.
Wall Mount DIN-Rail Pull High/low Resistors Setting for the RS-485 Port DIP switches on the bottom of NPort 5400 are used to set the pull high/low resistor values for each serial port. Pull High/low Resistors for the RS-485 Port SW Default NOTE ON OFF 1 Pull High 1KΩ 150KΩ 2 Pull Low 1KΩ 150KΩ 3 Terminator 120Ω – The operating temperature of the power adapter in the box is from 0 to 40°C.
NOTE For the NPort with DB Male serial ports, you may refer to the DB9 Male Ports pin assignment section to loop back pin 2 and pin 3 for the RS-232 interface to carry out a self test on the device. Pin Assignments and Cable Wiring DB9 Male Port Pinouts Pin assignments apply to NPort 5410 (RS-232 only), 5450, and 5450I.
DB9 Female to DB25 Male Terminal Block Wiring- NPort 5430/5430I Environmental Specifications Power requirements Input Voltage Power Consumption: NPort 5410 NPort 5430 NPort 5430I NPort 5450 NPort 5450I Operating temp. Standard Models Wide Temp.
