NPort 5200A Series Quick Installation Guide Edition 2.0, December 2015 Technical Support Contact Information www.moxa.
Overview NPort 5200A series device servers are compact, palm-sized data communication devices that allow you to control RS-232 (NPort 5210A), RS-422/485 (NPort 5230A), and RS-232/422/485 (NPort 5250A) serial devices over a TCP/IP-based Ethernet. NOTE “-T” indicates an extended temperature model.
Reset Button—Press and hold the Reset button for 5 seconds to load factory defaults: Use a pointed object, such as a straightened paper clip or toothpick, to depress the reset button. This will cause the Ready LED to blink on and off. The factory defaults will be loaded once the Ready LED stops blinking (after about 5 seconds). At this point, release the reset button. LED Indicators—NPort 5200A’s top panel has four LED indicators, which are described in the following table.
Hardware Installation Information STEP 1: After removing the NPort 5200A series device server from the box, connect the NPort 5200A series device server to a network. Use a standard straight-through Ethernet cable to connect to a hub or switch. When setting up or testing the NPort 5200A series device server, you might find it convenient to connect directly to your computer’s Ethernet port. In this case, use a cross-over Ethernet cable.
Pin Assignments Ethernet Port Pinouts Pin No. 1 2 3 6 Ethernet Tx+ TxRx+ Rx- NPort 5210A—DB9 male (RS-232) port pinouts Pin No. 1 2 3 4 5 6 7 8 9 RS-232 DCD RxD TxD DTR GND DSR RTS CTS – NPort 5230A—Terminal Block (RS-422/485) port pinouts Pin No. RS-422/485-4W RS-485-2W 1 TxD+(B) – 2 TxD-(A) – 3 RxD+(B) Data+(B) 4 RxD-(A) Data-(A) 5 GND GND NPort 5250A—DB9 male (RS-232/422/485) port pinouts Pin No.
Specifications Power Requirements Power Input Power Consumption Environmental Limits Operating Temperature Ambient Humidity Dimensions With ears Without ears Protection Serial Line Protection Magnetic Isolation Power Line Protection 12 to 48 VDC 119 mA @ 12V, 65 mA @ 24V Standard Models: 0 to 60°C (32 to 140°F) Wide Temp. Models: -40 to 75°C (-40 to 167°F) 5 to 95% RH 100 x 111 x 26 mm (3.94 x 4.37 x 1.02 in) 77 x 111 x 26 mm (3.03 x 4.37 x 1.02 in) Level 1 Surge, EN61000-4-5 1.
