Installation Guide

- 4 -
NPort 5450AI-M12 Appearance
The Reset to Default Button—Press the reset button to default button
for five seconds continuously to load the factory default settings. Use a
pointed object, such as a straightened paper clip or toothpick, to press
the reset button to default button. This will cause the Ready LED to blink
on and off. The factory default settings are loaded once the Ready LED
stops blinking (after about five seconds). At this point, you can release
the reset button to default button.
NPort 5000AI-M12 LED Indicators (front panel)
Name
Color
Function
PWR
green
Power is being supplied to the power input.
Ready
red
Steady on:
Power is on, and NPort is booting up.
Blinking:
Indicates an IP conflict, or the
DHCP/BOOTP server did not respond
properly.
green
Steady on: Power is on, and NPort is functioning
normally.
Blinking:
The NPort has been located by NPort
Administrator’s Location function.
off
Power is off, or a power error condition exists.
10M,
100M
orange
10 Mbps Ethernet connection.
green
100 Mbps Ethernet connection.
off
Ethernet cable is disconnected.
P1, P2,
P3, P4
orange
Serial port is receiving data.
green
Serial port is transmitting data.
off
No data is being transmitted or received through the
serial port.