MGate 5101-PBM-MN Quick Installation Guide Version 3.1, November 2019 Technical Support Contact Information www.moxa.
Overview The MGate 5101-PBM-MN is an industrial Ethernet gateway for PROFIBUS-to-Modbus-TCP network communication. Package Checklist Before installing the MGate 5101-PBM-MN, verify that the package contains the following items: • • • 1 MGate 5101-PBM-MN gateway Quick installation guide (printed) Warranty Card Please notify your sales representative if any of the above items are missing or damaged.
LED Color Amber Ethernet Green Off Function Steady: 10Mbps, no data is transmitting Blinking: 10Mbps, data is transmitting Steady: 100Mbps, no data is transmitting Blinking: 100Mbps, data is transmitting Ethernet cable is disconnected Reset Button The reset button is used to load factory defaults. Use a pointed object such as a straightened paper clip to hold the reset button down for five seconds. Release the reset button when the Ready LED stops blinking.
The following figure illustrates the two mounting options: Software Installation Information To install MGate Manager, please download it from Moxa’s website at http://www.moxa.com. For more detailed information about MGate Manager, click the Documents button and select the MGate 5101-PBM-MN User’s Manual. The MGate 5101 also supports login via a web browser. Default IP address: 192.168.127.
Power Input and Relay Output Pinouts V2+ Shielded Ground V1+ V2- DC DC Power Power Input 2 Input 2 N.O. Common N.C. V1- DC DC Power Power Input 1 Input 1 Specifications Power Input Power Consumption (Input Rating) Operating Temperature Storage Temperature 12 to 48 VDC 12 to 48 VDC, 360 mA (max.) Standard Models: 0 to 60°C (32 to 140°F) Wide Temp. Models: -40 to 75°C (-40 to 167°F) -40 to 85°C (-40 to 185°F) ATEX and IECEx Information 1. 2. 3. 4. 5. 6. 7. 8.
ATTENTION For installations in hazardous locations (Class 1, Division 2): These devices are to be installed in an enclosure with a tool-removable cover or door, suitable for the environment. NOTE The equipment must be suitable for use in Class 1, Division 2, Groups A, B, C, D, or nonhazardous locations only. WARNING EXPLOSION HAZARD Do not disconnect equipment unless the power has been switched off, or the area is known to be nonhazardous.