User`s manual

ioLogik E2260 User’s Manual Liquid Crystal Display Module (LCM)
A-2
Display Explanation / Actions
<ioLogik E2260>
network
Enter this submenu to display information and settings for the
network:
z ethernet link
z MAC address
z IP mode
z IP address
z netmask
z gateway
z DNS server-1
z DNS server-2
<ioLogik E2260>
click&go
Enter this submenu to display information about the ruleset
being used by the active I/O system.
z name
z status
<ioLogik E2260>
serial port
Enter this submenu to display the RS-485 cascade port settings.
<ioLogik E2260>
i/o setting
Enter this submenu to access I/O channel status. Here are
examples of settings that you might see:
z RTD-00 XXX
o
C
Press up or down to navigate through the different I/O channels
without having to go back to the previous menu.
<ioLogik E2260>
console
Enter this submenu to see if the web console is enabled or
disabled.
<ioLogik E2260>
ping
Select this option to enter an IP address to ping. If you get a
“timeout” error, it indicates that the E2260 cannot reach that IP
address. Otherwise, the display will show the response time.
<ioLogik E2260>
save/restart
Enter this submenu to display the restart now submenu. Enter
the restart now submenu to display the restart option. Press the
center button to modify this option, then select enable to save
changes and reboot the I/O server. The disable option has no
effect.
WARNING
Any configuration changes that are made through the LCM will not take effect until the ioLogik
E2260 is restarted.