User`s manual

ioLogik E2260 User’s Manual Utilities
3-17
Firmware Update Tab
The ioLogik E2260 supports remote firmware updates through the Firmware Update tab. Enter the
path to the firmware file or click on the icon to browse for the file. Click Update to update the
firmware. The wizard will lead you through the process until the server is restarted.
WARNING
Do not interrupt the firmware update process! An interruption in the process may result in
your device becoming unrecoverable.
After the firmware is updated, the ioLogik will restart and you will have to log in again to access
administrator functions.
The firmware on any attached I/O expansion module, such as an ioLogik R2000 server, must be
updated over the RS-485 bus. Firmware on cascaded modules cannot be updated over Ethernet.
Watchdog Tab
The Watchdog tab is where you configure the Host Connection Watchdog, which is used with the
Safe Status settings to define each DO channel’s response to a lost network connection. When the
Host Connection Watchdog is enabled, the ioLogik E2260 will respond to network disconnections
that exceed the specified amount of time. The ioLogik will respond by resetting DO channels to
their Safe Status settings. By default, the Watchdog is disabled. To enable the Watchdog, make
sure Enable Host Connection Watchdog is checked, set the Timeout value, then click the
Update button.