User Manual

- 5 -
Mounting
There are two ways to mount the ioLogik E2200 Series: DIN rail or wall
mounting.
• Mounting on a DIN rail
Pull out the bottom slider; latch the unit onto the DIN rail, and then
push the slider back in.
• Mounting on a wall
Pull out both the top and bottom sliders and align the
screws accordingly. The heads of the screws should
be less than 6.0 mm in diameter, and the shafts
should be less than 3.5 mm in diameter, as shown in
the figure.
Connecting to the ioLogik E2200
You have two ways to connect to the ioLogik E2200: by ioAdmin or by web
console.
• Default IP Address: 192.168.127.254
• Subnet Mask: 255.255.255.0
NOTE
Be sure to configure the host PC’s IP address to the same subnet
as the ioLogik E2200. For example, 192.168.127.253
Restore Factory Defaults
There are three ways to restore the ioLogik to factory default settings.
1. Hold the RESET button for 5 seconds.
2. Right-click on the specific ioLogik in the ioAdmin utility and select
Reset to Default.
3. Select Load Factory Default from the web console.
NOTE
Refer to the user's manual for detailed configuration and settings
information.