User Manual

- 2 -
Package Checklist
• 1 ioLogik E1200 series remote I/O product
• Quick installation guide (printed)
Specifications
System
Ethernet
2 x 10/100 Mbps switch ports, RJ45
Protection
1.5 KV magnetic isolation
Protocols
Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, HTTP
Power Input
24 VDC nominal, 12 to 36 VDC
Wiring
I/O cable max. 14 AWG
Dimensions
27.8 x 124 x 84 mm (1.09 x 4.88 x 3.31 in)
Weight
under 200 g
Operating Temperature
Standard Models:
-10 to 60°C (14 to 140°F)
Wide Temp. Models:
-40 to 75°C (-40 to 167°F)
Storage Temperature
-40 to 85°C (-40 to 185°F)
Ambient Relative
Humidity
5 to 95% (non-condensing)
Altitude
Up to 2000 m
Note: Contact Moxa if you require products guaranteed to function
properly at higher altitudes.
Standards and
Certifications
UL 508, CE, FCC Class A
Warranty Period
5 years (excluding ioLogik E1214*)
Details
See www.moxa.com/warranty
*Because of the limited lifetime of power relay, products that use this
component are covered by a 2-year warranty.
Digital Input
Sensor Type
NPN, PNP, and Dry contact
I/O Mode
DI or Event Counter
Dry Contact
• On: short to GND
• Off: open
Wet Contact (DI to COM)
• On: 10 to 30 VDC
• Off: 0 to 3 VDC
Isolation:
3K VDC or 2K Vrms
Counter/Frequency:
250 Hz, power off storage
Digital Output (Sink)
I/O Mode
DO or Pulse Output
Pulse Wave
Width/Frequency
1 ms/500 Hz
Over-voltage Protection
45 VDC
Over-current Protection
2.6 A (4 channels @650 mA)
Over-temperature
Shutdown
175°C (typical), 150°C (min.)
Current Rating
200 mA per channel
Isolation
3K VDC or 2K Vrms
Digital Output (Source)
I/O Mode
DO or Pulse Output
I/O Type
Source
Current
0.5A per channel