Datasheet

www.moxa.com
4
Relays
Breakdown Voltage 500 VAC
Connector Screw-fastened Euroblock terminal
Contact Current Rating Resistive load: 5 A @ 30 VDC, 250 VAC, 110 VAC
Contact Resistance 100 milli-ohms (max.)
Electrical Endurance 100,000 operations @ 5 A resistive load
Initial Insulation Resistance 1,000 mega-ohms (min.) @ 500 VDC
Mechanical Endurance 5,000,000 operations
Pulse Output Frequency 0.3 Hz at rated load (max.)
Type Form A (N.O.) power relay
Note Ambient humidity must be non-condensing and remain between 5 and 95%. The relays
may malfunction when operating in high condensation environments below 0°C.
Analog Inputs
Accuracy ioLogik E1240/E1242:
±0.1% FSR @ 25°C
±0.3% FSR @ -10 to 60°C
ioLogik E1240-T/E1242-T:
±0.1% FSR @ 25°C
±0.3% FSR @ -10 to 60°C
±0.5% FSR @ -40 to 75°C
Built-in Resistor for Current Input 120 ohms
Connector Screw-fastened Euroblock terminal
I/O Mode Voltage/Current
I/O Type Differential
Input Impedance 10 mega-ohms (min.)
Input Range 0 to 10 VDC
0 to 20 mA
4 to 20 mA
4 to 20 mA (with burn-out detection)
Resolution 16 bits
Sampling Rate ioLogik E1240: 12 samples/sec per module (shared between up to 8 channels)
3
ioLogik E1242: 12 samples/sec per module (shared between up to 4 channels)
3
Analog Outputs
Accuracy ioLogik E1241:
±0.1% FSR @ 25°C
±0.3% FSR @ -10 to 60°C
ioLogik E1241-T:
±0.1% FSR @ 25°C
±0.3% FSR @ -40 to 75°C
Connector Screw-fastened Euroblock terminal
Voltage Output Short-Circuit Protection 10 mA
Internal Resistor 400 ohms
3. If N channels are enabled, the sampling rate for each enabled channel = 12/N samples/sec.