User Manual

ioThinx 4510 Series Preface
1-3
Hardware and Software Requirements
You will need the following hardware and software to use the ioThinx 4510 Series.
• A power source that provides 12 to 48 VDC, and power wires
• A PC running a Windows OS with Chrome installed and an Ethernet cable
• 45MR modules, if available
• IOxpress software utility (optional)
• Moxa CLI Configuration Tool (optional)
Safety Precautions
Please observe the following safety precautions when installing and using the ioThinx 4510 Series:
DANGER
Never work on the device while the power source is switched on
. Disconnect all
power sources to the device
before
performing installation, repair, or maintenance work.
DANGER
Disconnect the p
ower when you want to remove or
replace components, or disconnect equipment unless the
area is known to be free of ignitable substances.
•
If you connect or disconnect the Removable Terminal Block when field power is applied, an electrical arc can
occur. This could cause an explosion when installed in hazardous locations. En
sure that power is removed
or the area is nonhazardous before installation.
•
If you connect or disconnect wiring while the power is on, an electrical arc can occur. This could cause an
explosion in hazardous environments. Ensure that power is removed or the area is nonhazardous before
installation.
•
Do not disconnect the unit unless the power has been disconnected or the area is known to be
nonhazardous. In a hazardous area, the unit must be powered down before removing it.
WARNING
This unit is sensitive to Electrostatic Discharge, which can cause internal damage and affect operations. Follow
these guidelines when you handle this unit:
•
Touch a grounded object to discharge potential static.
•
Wear an approved grounding wristband.
•
Do not touch connectors or pins on component boards.
•
Do not touch circuit components inside the equipment.
•
Use a static-safe workstation, if available.
•
Store the device in appropriate static-safe packaging when not in use.
WARNING
Check the voltage
supplied by the power source. Make sure
the voltage provided by the power source matches
the
voltage required by the device.