User Manual

ioThinx 4510 Series Hardware Installation
3-7
INFORMATION
W
hen
the I/O module is inserted into the correct position, the connection between the internal bus and
the previous module is established.
Removing the Unit from a DIN Rail
Take the following steps to remove the unit from a DIN rail.
Step 1: Use your finger to pull the release tab on the lower part of the module.
Step 2: Press the release tab (item 1 in the figure) and then remove the CPU module from the DIN rail (item
2 in the figure).
NOTE
D
isconnect all connections, including Ethernet, serial, and power cables, from the device
before removing the
device
from the DIN rail.